CCNA Practiced Tests

 What is the same for both copper and fiber interfaces when using SFP modules?

C

  • A. They support an inline optical attenuator to enhance signal strength
  • B. They accommodate single-mode and multi-mode in a single module
  • C. They provide minimal interruption to services by being hot-swappable
  • D. They offer reliable bandwidth up to 100 Mbps in half duplex mode

Which two functions are performed by the core layer in a three-tier architecture? (Choose two.) 

AC

  • A. Provide uninterrupted forwarding service
  • B. Inspect packets for malicious activity
  • C. Ensure timely data transfer between layers
  • D. Provide direct connectivity for end user devices
  • E. Police traffic that is sent to the edge of the network

What is a recommended approach to avoid co-channel congestion while installing access points that use the 2.4 GHz frequency?

A

  • A. different nonoverlapping channels
  • B. one overlapping channel
  • C. one nonoverlapping channel
  • D. different overlapping channels


Refer to the exhibit. Shortly after SiteA was connected to SiteB over a new single-mode fiber path, users at SiteA report intermittent connectivity issues with applications hosted at SiteB. What is the cause of the intermittent connectivity issue?

  • A. Interface errors are incrementing.
  • B. High usage is causing high latency.
  • C. An incorrect SFP media type was used at SiteA.
  • D. The sites were connected with the wrong cable type.


Answer : A

The only indicator of any issues here is the reliability 166/255 on SiteA. When the input and output errors increase, they affect the reliability counter. This indicates how likely it is that a packet can be delivered or received successfully. Reliability is calculated like this: reliability = number of packets / number of total frames.
The value of 255 is the highest value meaning that the interface is very reliable at the moment. The calculation above is done every 5 minutes.

Devices using a wireless LAN must operate in which one of the following modes?

the answer is (D) 

Comments

Popular posts from this blog

Chapter-9 - 39 answer question was wrong

Embracing Remedial Programs - A Stepping Stone to Success

Reaching Adulthood on Digital Content Reading and Viewing Management